UNIT LINK DESIGN
SERV-O-LINK's unique snap-lock chain link design allows any pitch length to be fabricated in a matter of seconds without splicing, master links or special tools. One stock size can fill a number of different requirements, thereby reducing inventory cost. The ease of installation can decrease assembly labor and enable the designer to simplify other system components such as die cast frames and shaft bearing plates.
HIGH STRENGTH TO WEIGHT RATIO
Although the chain weighs a mere 0.067 oz. per foot (1.9 gm/ft), it provides excellent service with running tension loads up to 2 pounds, and has an ultimate breaking strength of 7 pounds at 75° F. Sprocket weights ranging from 0.009 oz. to 0.097 oz. (0.26 gm to 2.7gm) keep the system inertia to a minimum.
To view gear specifications on-line, click here.
These drive components exhibit outstanding resistance to a wide range of chemicals and solvents. The ability to operate in high humidity and corrosive environments can be an added benefit in many applications.
The chain and sprockets are pre-lubricated and stress relived at elevated temperature. This is only one of many extra steps taken at SERV-O-LINK to assure the design engineer of reliable and consistently uniform drive components.
35 SPROCKET SIZES
The chain and mating sprockets are available from factory stock in a wide selection of both teeth and shaft bore sizes. No tooling cost or set-up charges.
© Copyright 1999-2017 by Serv-O-Link, Corp.